I bought a new spark plug. According to the box, it was pre-gapped. You trust the manufacturer. Maybe you should. But here is the hard truth. The factory settings may not be suitable for your engine. Not even close.
Shock happens. A plug gets tossed. It hit the floor. The gap shifts. Although it looks good, it can be off by a few tenths of a millimeter. Fractions are important in internal combustion engines.
Why gap adjustment is important
Before you get your hands on a wrench, you need to know the exact specification. Check your owner’s manual. if the book is missing, contact your retailer. Or ask an expert. Don’t guess.
The physics are simple but ruthless. Higher compression engines? A smaller gap is needed. More power? The gap is getting smaller. Why? Because the bigger the gap, the more voltage is needed from the ignition coil to jump this distance. If the coil is unable to deliver that punch, it fails. A weak spark. Lost power. Poor efficiency.
“The higher the engine compression, the more power it produces and the smaller the spark plug gap.”
How to Gap to a new spark plug
Bring your tools. You need a feeler gauge. Especially the wire type. The disc type is used for checking. the wire type for adjustments.
-
**Check the gap. ** Slide the correct gauge wire between the center electrode and the ground electrode. It should catch slightly. Resistance is your friend. If it slides loosely, it’s too wide. If it doesn’t fit, it’s too tight.
-
Widen the gap. ** If the plug is tight, hook the gauge only on the ground electrode. Pull gently. Do not touch the porcelain insulator. Do not touch the center electrode. If the porcelain breaks, the plug becomes trash. If you break the center electrode, metal shavings will in your cylinders. Either way, you’re screwed.
-
**Narrow the gap. ** If the plug is too loose, tap the ground electrode against a clean, soft surface. An anvil works. A hammer handle works. Just be careful. A light tap may be enough.
-
**Check again. ** Keep checking. Adjusting one way affects the other. You are dancing with millimeters here.
The Margin for Error
There are tolerance limit. When adjusting the gap, the distance from the target must not be greater or less than .008 inches (0.2 mm).
Why? This is because if you adjust too much, the electrodes will not align properly. The spark will arc incorrectly. Jump at the wrong time or don’t jump at all. The engine does not run smoothly. You end up wasting fuel. Horsepower is lost.
It’s not just about installing parts. You are tuning the ignition. Respect the gap.




















